DOOR CONTROL TRANSMITTER (w/o Smart Entry and Start System) > INSTALLATION |
| 1. INSTALL TRANSMITTER BATTERY (for Type A) |
![]() |
Install a new transmitter battery (lithium battery: CR1620) with the positive (+) side facing upward, as shown in the illustration.
| 2. INSTALL DOOR CONTROL TRANSMITTER PACKING (for Type A) |
![]() |
Install the door control transmitter packing as shown in the illustration.
| 3. INSTALL TRANSMITTER HOUSING COVER (for Type A) |
![]() |
Install the transmitter housing cover as shown in the illustration.
| 4. INSTALL TRANSMITTER BATTERY (for Type B) |
![]() |
Install a transmitter battery (lithium battery: CR2016) with the positive (+) side facing upward, as shown in the illustration.
![]() |
Install the cover.
| 5. INSTALL DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY (for Type B) |
![]() |
Install the door control transmitter module set sub-assembly into the transmitter housing case.
| 6. INSTALL TRANSMITTER HOUSING COVER (for Type B) |
![]() |
Install the transmitter housing cover to the transmitter housing case.
Check that the transmitter LED illuminates when the switch is pressed.