DOOR CONTROL TRANSMITTER (w/o Smart Entry and Start System) > REMOVAL |
| 1. REMOVE TRANSMITTER HOUSING COVER (for Type A) |
![]() |
Insert a precision screwdriver into the gap, and turn the screwdriver to remove the transmitter housing cover.
| *a | Protective Tape |
| 2. REMOVE DOOR CONTROL TRANSMITTER PACKING (for Type A) |
![]() |
Insert a precision screwdriver into the door control transmitter packing and turn the screwdriver to remove the door control transmitter packing.
| *a | Protective Tape |
| 3. REMOVE TRANSMITTER BATTERY (for Type A) |
![]() |
Insert a precision screwdriver into the gap and gently remove the transmitter battery (lithium battery: CR1620).
| *1 | Protective Tape |
| 4. REMOVE TRANSMITTER HOUSING COVER (for Type B) |
![]() |
Using a precision screwdriver with its tip wrapped in protective tape, pry open the transmitter housing cover.
| *a | Protective Tape |
| 5. REMOVE DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY (for Type B) |
![]() |
Using a precision screwdriver with its tip wrapped in protective tape, remove the door control transmitter module set sub-assembly from the transmitter housing case.
| *a | Protective Tape |
| 6. REMOVE TRANSMITTER BATTERY (for Type B) |
![]() |
Twist the coin in the direction of the arrow in the illustration, and remove the transmitter battery cover.
![]() |
Remove the transmitter battery (lithium battery: CR2016).