Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Front Floor)

ELECTRICAL KEY OSCILLATOR (for Front Floor) > REMOVAL

for Preparation Click here



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for TMC, TMMR Made)


    B430424
  1. Disengage the 2 claws and disconnect the shift hole cover sub-assembly as shown in the illustration.



    B430426
  1. Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.



2. REMOVE FRONT PANEL GARNISH LH (for TMC, TMMR Made)


    B386768
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish LH as shown in the illustration.



3. REMOVE FRONT PANEL GARNISH RH (for TMC, TMMR Made)


    B386771
  1. Disengage the 3 clips and 8 guides to remove the front panel garnish RH.



4. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY (for TMC, TMMR Made)
  1. Move the shift lever to N.



  1. Disengage the 6 clips as shown in the illustration.


    B430428

  1. Disconnect each connector to remove the rear console upper panel sub-assembly.



5. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY (for TMC, TMMR Made)


    B278005
  1. Remove the 2 screws.



    B277989
  1. Disengage the 4 clips and 2 guides as shown in the illustration.



    B280337
  1. Disengage the clamp.

  1. Disconnect the 2 connectors to remove the upper console box sub-assembly.



6. REMOVE NO. 4 CONSOLE BOX DUCT (for TMC, TMMR Made)


    B293623
  1. Disengage the claw and remove the No. 4 console box duct.



7. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY (for TMMK Made)


    B377618
  1. Disengage the 4 clips and remove the upper console box sub-assembly.

  1. w/ Seat Heater System:

    1. Disconnect each connector.



8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for TMMK Made)


    B377615
  1. Disengage the 2 claws as shown in the illustration.



    B377616
  1. Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.



9. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY (for TMMK Made)
  1. Move the shift lever to N.



    B403737
  1. Disconnect the connector.

  1. Remove the 2 screws <C> or <D>.



    B377620
  1. Disengage the 6 clips and remove the rear console upper panel sub-assembly.



10. REMOVE NO. 4 CONSOLE BOX DUCT (for TMMK Made)


    B293623
  1. Disengage the claw and remove the No. 4 console box duct.



11. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    B279162
  1. Disengage the clamp.

  1. Remove the bolt.

  1. Disconnect the connector to remove the No. 1 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the No. 1 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.