Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Center Floor)

ELECTRICAL KEY OSCILLATOR (for Center Floor) > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY (for TMC, TMMR Made)
  1. for Fold Down Seat Type:
  2. for Reclining Seat Type:


2. REMOVE REAR SEAT CUSHION ASSEMBLY (for TMMK Made)


    B279202E01
  1. Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
    Standard Measurement 
    a
    100 mm (3.94 in.) or less

    NOTICE:
    Be sure to hold the part of the rear seat cushion assembly directly next to the rear seat cushion lock hooks when lifting it up. Lifting a different part of the rear seat cushion assembly may deform the rear seat cushion frame.

  1. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.

    NOTICE:
    Be careful not to damage the vehicle body.



3. REMOVE REAR SEAT CUSHION LOCK HOOK (for TMC, TMMR Made)
  1. for Fold Down Seat Type:
  2. for Reclining Seat Type:


4. REMOVE REAR SEAT CUSHION LOCK HOOK (for TMMK Made)


    B393387
  1. Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the RH side and the LH side.



5. REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for TMC, TMMR Made)


    B279933
  1. Disconnect the connector.

  1. Remove the 2 bolts and No. 2 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the No. 2 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.



6. REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (for TMMK Made)


    B279164
  1. Disconnect the connector.

  1. Disengage the clamp to remove the No. 2 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the No. 2 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.