SHIFT PADDLE SWITCH > INSTALLATION |
| 1. CONNECT NO. 1 SWITCH WIRE |
Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).
![]() |
Install new 2 clamps as shown in the illustration.
| *1 | Clamp |
| *a | 0 to 40° |
| *b | 1 to 3 mm |
Engage the 5 guides to install the No. 1 switch wire.
| 2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) |
Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.
| 3. INSTALL STEERING PAD SWITCH ASSEMBLY |
Engage the 2 claws, 2 pins and 2 guides to install the steering pad switch assembly.
Install the 2 screws.
w/ Shift Paddle Switch Wire of Steering Pad Switch Assembly:
Engage the clamp.
Connect the steering pad switch connector to the spiral cable sub-assembly.
![]() |
Pass the wire harness over the 2 guides.
| 4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD |
| 5. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
| 6. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.
| *a | Matchmark |
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly.
| 7. CHECK STEERING WHEEL CENTER POINT |
| 8. INSTALL HORN BUTTON ASSEMBLY |