SHIFT PADDLE SWITCH > INSPECTION |
| 1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) |
![]() |
Measure the resistance between each terminal when the shift paddle switch (transmission shift switch assembly) is moved to each position.
| Tester Connection | Switch Condition | Specified Condition |
| 3 (ECC) - 2 (SFTD) | Pull "-" continuously (Down-shift) | Below 1 Ω |
| Release | 10 kΩ or higher | |
| 4 (ECC1) - 2 (SFTD) | Pull "-" continuously (Down-shift) | Below 1 Ω |
| Release | 10 kΩ or higher |
| Tester Connection | Switch Condition | Specified Condition |
| 3 (SFTU) - 2 (ECC1) | Pull "+" continuously (Up-shift) | Below 1 Ω |
| Release | 10 kΩ or higher |
| *a | Component without harness connected (transmission shift switch LH) |
| *b | Component without harness connected (transmission shift switch RH) |