Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made)

REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE REAR COMBINATION LIGHT PACKING


    E300999
  1. Disengage the 2 guides and remove the rear combination light packing.

    NOTICE:
    1. Be sure to remove any remaining old packing from the vehicle body.
    2. Do not reuse the removed packing. Be sure to install a new rear combination light packing to prevent water ingress.



2. REMOVE REAR TURN SIGNAL LIGHT BULB


    E301000
  1. Turn the rear turn signal light socket with the rear turn signal light bulb as shown in the illustration to remove them as a unit.

  1. Remove the rear turn signal light bulb from the rear turn signal light socket.



3. REMOVE TAIL AND STOP LIGHT BULB


    E301002
  1. Turn the tail and stop light socket with the tail and stop light bulb as shown in the illustration to remove them as a unit.

  1. Remove the tail and stop light bulb from the tail and stop light socket.



4. REMOVE REAR BUMPER UPPER SIDE RETAINER


    E301004
  1. Using a screwdriver, disengage the claw and remove the rear bumper upper side retainer as shown in the illustration.