Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for TMC, TMMR Made)

REAR COMBINATION LIGHT ASSEMBLY (for TMC, TMMR Made) > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL REAR BUMPER UPPER SIDE RETAINER


    E301914
  1. Engage the claw to install the rear bumper upper side retainer as shown in the illustration.



2. INSTALL REAR TURN SIGNAL LIGHT BULB
  1. Install the rear turn signal light bulb to the rear turn signal light socket.



    E301912
  1. Turn the rear turn signal light socket with the rear turn signal light bulb as shown in the illustration to install them as a unit.



3. INSTALL REAR COMBINATION LIGHT CORD


    E301910
  1. Connect the connector.

  1. Engage the clamp to install the rear combination light cord.



4. INSTALL REAR COMBINATION LIGHT PACKING


    E301909
  1. Install a new rear combination light packing.