Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made)

REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made) > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL REAR BUMPER UPPER SIDE RETAINER


    E301005
  1. Engage the claw to install the rear bumper upper side retainer as shown in the illustration.



2. INSTALL TAIL AND STOP LIGHT BULB
  1. Install the tail and stop light bulb to the tail and stop light socket.



    E301003
  1. Turn the tail and stop light socket with the tail and stop light bulb as shown in the illustration to install them as a unit.



3. INSTALL REAR TURN SIGNAL LIGHT BULB
  1. Install the rear turn signal light bulb to the rear turn signal light socket.



    E301001
  1. Turn the rear turn signal light socket with the rear turn signal light bulb as shown in the illustration to install them as a unit.



4. INSTALL REAR COMBINATION LIGHT PACKING


    E300999
  1. Engage the 2 guides to install a new rear combination light packing.