RADIO ANTENNA CORD (for TMC, TMMR Made) > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY |
| 2. REMOVE NO. 3 HEATER TO REGISTER DUCT (for LHD) |
![]() |
Remove the clip.
Remove the 3 screws <C> and No. 3 heater to register duct.
| 3. REMOVE HEATER TO REGISTER DUCT ASSEMBLY (for RHD) |
![]() |
Remove the clip.
Remove the 3 screws <C>.
Disengage the heater to register duct assembly from the ion generator assembly, to remove the heater to register duct.
| 4. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT |
![]() |
Remove the screw <C>.
Disengage the 2 claws to remove the No. 2 side defroster nozzle duct.
| 5. REMOVE ANTENNA CORD SUB-ASSEMBLY |
for LHD:
Disengage the 8 clamps and remove the antenna cord sub-assembly.

for RHD:
Disengage the 10 clamps and remove the antenna cord sub-assembly.

| 6. REMOVE ROOF HEADLINING ASSEMBLY |
| 7. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof) |
w/ Television Antenna:
| 8. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.
Remove the No. 2 antenna cord sub-assembly from the roof headlining.

| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *C | w/ Television Antenna | - | - |
![]() | Front | ![]() | Tape |