RADIO ANTENNA CORD (for TMMK Made) > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY |
| 2. REMOVE NO. 3 HEATER TO REGISTER DUCT |
![]() |
Remove the clip.
Remove the 3 screws <C> or <D> or <H> and No. 3 heater to register duct.
| 3. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT |
![]() |
Remove the screw <C> or <D> or <H>.
Disengage the 2 claws to remove the No. 2 side defroster nozzle duct.
| 4. REMOVE ANTENNA CORD SUB-ASSEMBLY |
Disengage the 8 clamps and remove the antenna cord sub-assembly.

| 5. REMOVE ROOF HEADLINING ASSEMBLY |
| 6. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.
Remove the No. 2 antenna cord sub-assembly from the roof headlining.

| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *1 | Tape | - | - |
| *a | Front | - | - |