Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE

WASHER NOZZLE > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WASHER NOZZLE SUB-ASSEMBLY


  1. for TMC, TMMR Made:



    1. Operate the washer nozzle sub-assembly and check the position that the washer fluid hits the windshield.

      Standard:
      Washer fluid hits the windshield in the areas shown in the illustration.



      E226091E01


      Standard Clearance 
      Area
      Measurement
      Area
      Measurement
      A
      300.0 mm (11.8 in.)
      B
      145.0 mm (5.71 in.)
      C
      170.0 mm (6.69 in.)
      -
      -

      Text in Illustration 
      *a
      Upper Limit
      *b
      Standard
      *c
      Lower Limit
      -
      -

      HINT:
      If the result is not as specified, replace the washer nozzle sub-assembly.



  1. for TMMK Made:



    1. Operate the washer nozzle sub-assembly and check the position that the washer fluid hits the windshield.

      Standard:
      Washer fluid hits the windshield in the areas shown in the illustration.



      E226091E10


      Standard Clearance 
      Area
      Measurement
      Area
      Measurement
      A
      300.0 mm (11.8 in.)
      B
      145.0 mm (5.71 in.)
      C
      175.0 mm (6.89 in.)
      -
      -

      Text in Illustration 
      *a
      Upper Limit
      *b
      Standard
      *c
      Lower Limit
      -
      -

      HINT:
      If the result is not as specified, replace the washer nozzle sub-assembly.