FRONT WIPER MOTOR > REMOVAL |
| 1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH |
![]() |
Remove the nut and front wiper arm and blade assembly LH.
| 2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH |
![]() |
Remove the nut and front wiper arm and blade assembly RH.
| 3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH |
for TMC, TMMR Made:
![]() |
Disengage the 2 clips and 3 guides and remove the front fender to cowl side seal LH as shown in the illustration.
for TMMK Made:
![]() |
Disengage the 2 clips and guide and remove the front fender to cowl side seal LH as shown in the illustration.
| 4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH |
| 5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
Disengage the 6 claws and guide as shown in the illustration.

Disengage the 8 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.

| 6. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD) |
Operate the wiper and stop the windshield wiper motor at the automatic stop position.
![]() |
Disconnect the connector.
| *1 | Motor Grommet |
Remove the 2 bolts.
Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.
| 7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD) |
Operate the wiper and stop the windshield wiper motor at the automatic stop position.
![]() |
Disengage the 2 clamps and then disconnect the connector.
| *1 | Motor Grommet |
Remove the 2 bolts.
Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.
| 8. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY |
![]() |
Using a screwdriver, separate the No. 1 rod from the windshield wiper motor assembly as shown in the illustration.
| *1 | Protective Tape |
![]() |
Using a T30 "TORX" socket wrench, remove the 2 bolts and windshield wiper motor assembly from the wiper link assembly.