FRONT DOOR LOCK (for TMMK Made) > INSPECTION |
| 1. INSPECT FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH |
![]() |
Check the operation of the door lock motor.
Apply battery voltage and check the operation of the door lock motor.
| Battery Connection | Result |
| Battery positive (+) → Terminal 4 (L) Battery negative (-) → Terminal 1 (UL) | Locks |
| Battery positive (+) → Terminal 1 (UL) Battery negative (-) → Terminal 4 (L) | Unlocks |
| *a | Component without harness connected (Front Door Lock with Motor Assembly LH) |
| *b | Unlock |
| *c | Lock |
![]() |
Check the operation of the door unlock detection switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 7 (E) - 8 (LSSR) | Locked | 10 kΩ or higher |
| 7 (E) - 8 (LSSR) | Unlocked | Below 1 Ω |
| *a | Component without harness connected (Front Door Lock with Motor Assembly LH) |
| *b | Unlock |
| *c | Lock |
![]() |
Check the operation of the door key lock and unlock switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 9 (L) - 7 (E) | Held to lock side | Below 1 Ω |
| 9 (L) - 7 (E) | Neutral or held to unlock side | 10 kΩ or higher |
| 10 (UL) - 7 (E) | Held to unlock side | Below 1 Ω |
| 10 (UL) - 7 (E) | Neutral or held to lock side | 10 kΩ or higher |
| *a | Component without harness connected (Front Door Lock with Motor Assembly LH) |
| *b | Unlock |
| *c | Lock |
| 2. INSPECT FRONT DOOR LOCK WITH MOTOR ASSEMBLY RH |
![]() |
Check the operation of the door lock motor.
Apply battery voltage and check the operation of the door lock motor.
| Battery Connection | Result |
| Battery positive (+) → Terminal 4 (L) Battery negative (-) → Terminal 1 (UL) | Locks |
| Battery positive (+) → Terminal 1 (UL) Battery negative (-) → Terminal 4 (L) | Unlocks |
| *a | Component without harness connected (Front Door Lock with Motor Assembly RH) |
| *b | Unlock |
| *c | Lock |
![]() |
Check the operation of the door unlock detection switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 7 (LSSR) - 8 (E) | Locked | 10 kΩ or higher |
| 7 (LSSR) - 8 (E) | Unlocked | Below 1 Ω |
| *a | Component without harness connected (Front Door Lock with Motor Assembly RH) |
| *b | Unlock |
| *c | Lock |