DTC B1243 GSW Terminal Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1243 | A malfunction occurs in the GSW input circuit of the main body ECU (multiplex network body ECU). |
|

| 1.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||
| 2.CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (GSW VOLTAGE) |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the I47 airbag sensor assembly connector.
Connect the cable to the negative (-) battery terminal.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I47-18 (GSW) - Body ground | ignition switch to ON | 2.8 to 4.3 V |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
|
| ||||
| OK | |
| 3.REPLACE AIRBAG SENSOR ASSEMBLY |
Disconnect the cable from the negative (-) battery terminal.
Replace the airbag sensor assembly (for TMMK Made) (Click here).
Replace the airbag sensor assembly (for TMC, TMMR Made) (Click here).
| NEXT | |
| 4.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (AIRBAG SENSOR ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK) |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the I47 airbag sensor assembly connector.
Disconnect the 3A instrument panel junction block connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I47-18 (GSW) - 3A-45 | Always | Below 1 Ω |
| 3A-45 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly (Click here).
Remove the main body ECU (multiplex network body ECU).

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MB-24 (GSW) - 3A-45 | Always | Below 1 Ω |
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
|
| ||||
| OK | ||
| ||