Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR (for TMMK Made)

OUTER REAR VIEW MIRROR (for TMMK Made) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
  1. Engage the clip.



    B381034E01
  1. Engage the claw to temporarily install the outer rear view mirror assembly.

  1. Install the 3 bolts.

    HINT:
    Tighten the bolts in the order shown in the illustration.

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }

  1. Connect the connector.

  1. Install the outer rear view mirror assembly with the clip.



2. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH


    B380648
  1. Engage the 3 clips to install the front door lower frame bracket garnish.



3. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP


    B380651
  1. Install the front door inner glass weatherstrip.



4. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B380645E01
  1. Connect the front door lock remote control cable assembly and front door inside locking cable assembly as shown in the illustration.
    Text in Illustration 
    *1
    Front Door Inside Locking Cable Assembly
    *2
    Front Door Lock Remote Control Cable Assembly

  1. Engage the clamp.



    B380643E01
  1. Engage the 4 claws and reference boss as shown in the illustration.
    Text in Illustration 
    *a
    Reference Boss



    B380641
  1. Engage the 10 clips to install the front door trim board sub-assembly.

  1. Install the 3 screws.



5. INSTALL COURTESY LIGHT ASSEMBLY
  1. Connect the connector.



    E226715E01
  1. Engage the claw to install the courtesy light assembly.
    Text in Illustration 
    *A
    for LH Side
    *B
    for RH Side



6. INSTALL FRONT ARMREST ASSEMBLY


    B277188
  1. Engage the 2 guides, 3 clips and 7 claws to install the front armrest assembly.



7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
  1. Connect each connector.



    B380636
  1. Engage the 3 guides, 2 clips and 6 claws to install the power window regulator master switch assembly with front door armrest base panel.



8. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
  1. Connect each connector.



    B401213
  1. Engage the 3 guides, 2 clips and 6 claws to install the power window regulator switch assembly with front door armrest base panel.



9. INSTALL FRONT DOOR FRONT LOWER FRAME UPPER COVER


    B380639
  1. Engage the 2 guides and 2 claws to install the front door front lower frame upper cover.



10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B381716
  1. Engage the 3 claws to install the front door inside handle bezel plug.