Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Disconnect the main body ECU (multiplex network body ECU) connectors.


    B282096E19


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD

  2. Measure the resistance and voltage according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    MB-30 (BECU) - Body ground
    -
    Battery power supply
    Always
    11 to 14 V
    MB-31 (ALTB) - Body ground
    -
    Battery power supply
    Always
    11 to 14 V
    MB-32 (IG) - Body ground
    -
    Ignition power supply (IG signal)
    Ignition switch ON → OFF
    11 to 14 V → Below 1 V
    MB-29 (ACC) - Body ground
    -
    Ignition power supply (ACC signal)
    Ignition switch ACC → OFF
    11 to 14 V → Below 1 V
    MB-11 (GND1) - Body ground
    -
    Ground
    Always
    Below 1 Ω
    I12-3 (GND2) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    MB-2 (FLCY) - Body ground
    -
    Front door courtesy light switch LH input
    Front door LH closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    I13-19 (FRCY) - Body ground
    Y - Body ground
    Front door courtesy light switch RH input
    Front door RH closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    I13-1 (LCTY) - Body ground
    P - Body ground
    Rear door courtesy light switch LH input
    Rear door LH closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    I13-6 (RCTY) - Body ground
    B - Body ground
    Rear door courtesy light switch RH input
    Rear door RH closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    MB-4 (LGCY) - Body ground
    -
    Luggage compartment door courtesy light switch input
    Luggage compartment door closed (OFF) → open (ON)
    10 kΩ or higher → Below 1 Ω
    MB-20 (HCTY) - Body ground
    -
    Engine hood courtesy switch input
    Engine hood open (OFF) → closed (ON)
    10 kΩ or higher → Below 1 Ω
    I13-17 (KSW) - Body ground*
    G - Body ground
    Unlock warning switch input
    Key is not in the key cylinder (OFF) → Key is in the key cylinder (ON)
    10 kΩ or higher → Below 1 Ω
    1. *: w/o Smart Entry and Start System
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the main body ECU (multiplex network body ECU) connectors.

  4. Measure the voltage and resistance according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    I13-7 (LSFL) - Body ground
    V - Body ground
    Front door LH unlock detection switch input
    Front door LH unlocked
    Below 1 V
    I13-7 (LSFL) - Body ground
    V - Body ground
    Front door LH unlock detection switch input
    Front door LH locked
    Pulse generation
    I13-18 (LSFR) - Body ground
    W - Body ground
    Front door RH unlock detection switch input
    Front door RH unlocked
    Below 1 V
    I13-18 (LSFR) - Body ground
    W - Body ground
    Front door RH unlock detection switch input
    Front door RH locked
    Pulse generation
    3C-17 (LSR) - Body ground
    LG - Body ground
    Rear door LH unlock detection switch input
    Rear door LH or RH unlocked
    Below 1 V
    3C-17 (LSR) - Body ground
    LG - Body ground
    Rear door LH unlock detection switch input
    Rear door LH and RH locked
    Pulse generation
    3A-53 (LSR) - Body ground
    Y - Body ground
    Rear door RH unlock detection switch input
    Rear door RH or LH unlocked
    Below 1 V
    3A-53 (LSR) - Body ground
    Y - Body ground
    Rear door RH unlock detection switch input
    Rear door RH and LH locked
    Pulse generation
    I12-22 (IND) - Body ground*
    L - Body ground
    Security indicator illumination
    Security indicator light illuminates
    (It illuminates only for 27.5 sec. in alarm sounding state.)
    3 to 10 V
    3D-14 (SH) - Body ground
    R - Body ground
    Security horn drive
    Security horn sounding
    (Theft deterrent system is in alarm sounding state)
    Pulse generation
    (Below 1 V ← → 11 to 14 V)
    3D-15 (HORN) - Body ground
    SB - Body ground
    Vehicle horn drive
    Vehicle horns sounding
    (Theft deterrent system is in alarm sounding state)
    Pulse generation
    (Below 1 V ← → 11 to 14 V)

    1. *: w/o Smart Entry and Start System
    If the result is not as specified, the main body ECU (multiplex network body ECU) may have a malfunction.