THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Hood Courtesy SW | Engine hood courtesy switch/ON or OFF | ON: Engine hood open OFF: Engine hood closed | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the main body ECU (multiplex network body ECU) (Click here).

| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | - | - |
Disconnect the 3D instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3D-25 - MB-20 (HCTY) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) |
Remove the hood lock assembly (Click here).

| *A | for LHD | *B | for RHD |
| *1 | Opened | *2 | Locked |
| *a | Component without harness connected (Engine Hood Courtesy Switch (Hood Lock Assembly)) | - | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Opened | 10 kΩ or higher |
| 1 - 2 | Locked | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ENGINE HOOD COURTESY SWITCH - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A2-1 - 3D-25 | Always | Below 1 Ω |
| A2-1 - Body ground | Always | 10 kΩ or higher |
| A2-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||