Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure for all No. 1 ultrasonic sensor retainers.



    E301652E01
  1. Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.
    Text in Illustration 
    *a
    Cutout
    *b
    Protrusion

    NOTICE:
    1. Do not damage the rear bumper assembly with the protrusion when installing the No. 1 ultrasonic sensor retainer.
    2. Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the No. 1 ultrasonic sensor retainer and surface of the rear bumper assembly.

    HINT:
    1. When installing the retainer, align the cutout and protrusion as shown in the illustration.
    2. This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



2. INSTALL NO. 1 ULTRASONIC SENSOR

HINT:
Use the same procedure for all No. 1 ultrasonic sensors.

  1. Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

    NOTICE:
    Push the No. 1 ultrasonic sensor retainer from the outside of the rear bumper assembly when there is a gap between the No. 1 ultrasonic sensor retainer and the rear bumper assembly surface. In this case, do not push on the No. 1 ultrasonic sensor.



3. INSTALL ULTRASONIC SENSOR CLIP

HINT:
Use the same procedure for all ultrasonic sensor clips.

  1. Engage the 4 claws to install the ultrasonic sensor clip.



4. INSTALL NO. 2 LUGGAGE ROOM WIRE

HINT:
Use the same procedure for all connectors.

  1. Connect the connector to install the No. 2 luggage room wire.

  1. Engage the clamp.



5. INSTALL REAR BUMPER ASSEMBLY
(Click here)