Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR

BLIND SPOT MONITOR SENSOR > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER ASSEMBLY
(Click here)


2. REMOVE BLIND SPOT MONITOR SENSOR LH

NOTICE:
Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.



    E226447
  1. Disengage the 2 clamps.



    E226449
  1. Remove the 3 nuts.



    E267787
  1. Disconnect the connector to remove the blind spot monitor sensor LH.



3. REMOVE BLIND SPOT MONITOR SENSOR RH

NOTICE:
Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.



    E226448
  1. Disengage the clamp.



    E266119
  1. Remove the 3 nuts.



    E226450
  1. Disconnect the connector to remove the blind spot monitor sensor RH.



4. REMOVE BLIND SPOT MONITOR COVER LH


    E226407
  1. Remove the 2 nuts.

  1. Disengage the claw to remove the blind spot monitor cover LH.



5. REMOVE BLIND SPOT MONITOR COVER RH

HINT:
Use the same procedure as for the LH side.