INSTRUMENT PANEL SPEAKER (for TMC, TMMR Made) > INSTALLATION |
| 1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY |
Connect the connector.
![]() |
Install the front No. 2 speaker assembly with the 2 screws.
| *A | LH Side |
| *B | RH Side |
| 2. INSTALL INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY |
![]() |
Engage the 2 guides.
Engage the 3 claws and 2 clips to install the No. 1 instrument panel speaker panel sub-assembly.
| 3. INSTALL FRONT PILLAR GARNISH |
Remove the protective cover.
Make sure that the front pillar garnish clip is not damaged.
![]() ![]() |
Install the front pillar garnish clip to front pillar garnish LH.
| *a | Correct | *b | Incorrect |
Engage the 2 guides as shown in the illustration.
![]() |
Engage the 2 clips to install the front pillar garnish LH.
| 4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 5. INSTALL FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers) |
Connect the connector.
![]() |
Install the front No. 3 speaker assembly with the 2 screws.
| 6. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY (for 10 Speakers) |
Connect the connector.
![]() |
Engage the 6 clips to install the No. 1 speaker opening cover assembly.
| 7. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for 10 Speakers) |
Connect the connector.
![]() |
Engage the 4 clips to install the No. 2 instrument panel register assembly.
| 8. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 10 Speakers) |
![]() |
Engage the 7 clips and 2 guides to install the center instrument cluster finish panel sub-assembly.