Home › Audio / Visual / Telematics › AUDIO / VIDEO › INSTRUMENT PANEL SPEAKER (for TMMK Made)

INSTRUMENT PANEL SPEAKER (for TMMK Made) > REMOVAL

for Preparation Click here


NOTICE:
for Side:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B399740
  1. Disconnect the front door opening trim weatherstrip LH.



2. REMOVE FRONT PILLAR GARNISH


    B379543E01
  1. Pull the upper part of the garnish toward the inside of the cabin and disengage the garnish from the base of the 2 clips.
    Text in Illustration 
    *1
    Front Pillar Garnish Clip

    HINT:
    Make the front pillar garnish LH hang from the front pillar garnish clip.



    B379544E02
  1. While pushing the tabs of the front pillar garnish clip in the direction indicated by the arrows (A) shown in the illustration, disengage the front pillar garnish clip.

    NOTICE:
    Do not apply excessive force using a tool.

  1. Pull the garnish in the direction indicated by the arrow (B) shown in the illustration to disengage the 2 guides and remove the front pillar garnish LH.

  1. Remove the 2 clips from the front pillar garnish LH.



    B278988E02
  1. Protect the curtain shield airbag assembly LH.
    Text in Illustration 
    *1
    Curtain Shield Airbag Assembly LH
    *a
    Protective Cover
    V100155
    Adhesive Tape

    1. Cover the curtain shield airbag assembly LH with a piece of cloth or nylon and secure the edges of the cover with tape as shown in the illustration.

      NOTICE:
      Cover the curtain shield airbag assembly LH with a protective cover as soon as the front pillar garnish LH is removed.



3. REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    B280301
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    V100155
    Protective Tape



    B280302
  1. Using a moulding remover, disengage the 2 clips and 3 claws.

  1. Disengage the 2 guides to remove the No. 1 instrument panel speaker panel sub-assembly.



4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

NOTICE:
Do not touch the speaker cone.



    E300880
  1. Remove the 2 screws.

  1. Lift the front No. 2 speaker assembly and disconnect the connector to remove the speaker.



5. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY (for 10 Speakers)


    B377624
  1. Using a moulding remover, disengage the 11 clips as shown in the illustration.

  1. Disconnect the connector to remove the No. 1 speaker opening cover assembly.



6. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers)

NOTICE:
Do not touch the speaker cone.



    E300881
  1. Remove the 2 screws.

  1. Lift the front No. 3 speaker assembly and disconnect the connector to remove the speaker.