INSTRUMENT PANEL SPEAKER (for TMC, TMMR Made) > REMOVAL |
| 1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Disconnect the front door opening trim weatherstrip LH.
| 2. REMOVE FRONT PILLAR GARNISH |
![]() |
Pull the upper part of the garnish toward the inside of the cabin and disengage the garnish from the base of the 2 clips.
| *1 | Front Pillar Garnish Clip |
![]() |
While pushing the tabs on the front pillar garnish clip in the direction indicated by the arrow (A) shown in the illustration, disengage the front pillar garnish clip.
Pull the garnish in the direction indicated by the arrow (B) shown in the illustration to disengage the 2 guides and remove the front pillar garnish LH.
![]() |
Protect the curtain shield airbag assembly.
| *1 | Adhesive Tape |
| *2 | Protective Cover |
| *3 | Curtain Shield Airbag Assembly |
Cover the airbag with a piece of cloth or nylon and secure the edges of the cover with tape as shown in the illustration.
| 3. REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Using a moulding remover, disengage the 2 clips and 3 claws.
Disengage the 2 guides to remove the No. 1 instrument panel speaker panel sub-assembly.
| 4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY |
![]() |
Remove the 2 screws.
![]() |
Lift the front No. 2 speaker assembly and disconnect the connector to remove the speaker.
| 5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for 10 Speakers) |
![]() |
Using a moulding remover, pry up on the center instrument cluster finish panel sub-assembly until there is enough of a gap to make it possible to pull on the panel by hand.
![]() |
Pull the center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 7 clips and 2 guides to remove the center instrument cluster finish panel sub-assembly as shown in the illustration.
| 6. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for 10 Speakers) |
![]() |
Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 4 clips as shown in the illustration.
Disconnect the connector to remove the No. 2 instrument panel register assembly.
| 7. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY (for 10 Speakers) |
![]() |
Disengage the 6 clips as shown in the illustration.
Disconnect the connector to remove the No. 1 speaker opening cover assembly.
| 8. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY (for 10 Speakers) |
![]() |
Remove the 2 screws.
![]() |
Lift the front No. 3 speaker assembly and disconnect the connector to remove the speaker.