Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ECU

NAVIGATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL NAVIGATION ECU


2. INSTALL NO. 1 NAVIGATION WIRE
  1. Connect the 2 connectors to install the No. 1 navigation wire.



3. INSTALL ANTENNA CORD SUB-ASSEMBLY
  1. Connect the connector.

  1. Engage the clamp to install the antenna cord sub-assembly.



4. INSTALL NAVIGATION COMPUTER ASSEMBLY WITH WIRE
  1. Connect the 3 connectors to install the navigation computer assembly with wire.



5. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
  1. Engage the 4 clips to install the air conditioning control assembly.



6. INSTALL NO. 1 RADIO BRACKET
  1. w/o Navigation System:

    1. Install the No. 1 radio bracket with the 4 screws.

  1. w/ Navigation System:

    1. Install the No. 1 radio bracket with the 6 screws.



7. INSTALL NO. 2 RADIO BRACKET
  1. w/o Navigation System:

    1. Install the No. 2 radio bracket with the 4 screws.

  1. w/ Navigation System:

    1. Install the No. 2 radio bracket with the 6 screws.



8. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY
  1. Connect each connector.

  1. Engage the 6 clips to the vehicle body to temporarily install the radio receiver assembly with air conditioning control assembly.

  1. Install the radio receiver assembly with air conditioning control assembly with the 4 bolts.



9. INSTALL FRONT CONSOLE UPPER PANEL GARNISH


  1. for Blank Type:



      B386779
    1. Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.



  1. for 3 Switch Hole Type:

    1. Connect each connector.



    2. B386773
    3. Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.



10. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
  1. Connect the connector.



    B384416
  1. Engage the 4 clips to install the No. 2 instrument panel register assembly.

    NOTICE:
    When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.



11. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B283351
  1. Engage the 7 clips and 2 guides to install the center instrument cluster finish panel sub-assembly.



12. INSTALL FRONT PANEL GARNISH LH


    B386775
  1. Engage the 3 clips and 8 guides to install the front panel garnish LH.



13. INSTALL FRONT PANEL GARNISH RH


    B386774
  1. Engage the 3 clips and 8 guides to install the front panel garnish RH.