OUTER REAR VIEW MIRROR GLASS (for TMC, TMMR Made) > REMOVAL |
| 1. REMOVE OUTER MIRROR (w/o Memory) |
![]() |
Apply protective tape to the area shown in the illustration.
| *a | Protective Tape |
Push the upper part of the mirror surface and tilt it.
![]() |
Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.
| *a | Moulding Remover |
![]() |
Disengage the 2 guides as shown in the illustration.
![]() |
Disconnect the 2 connectors and remove the outer mirror.
| 2. REMOVE OUTER MIRROR (w/ Memory) |
![]() |
Apply protective tape to the area shown in the illustration.
| *a | Protective Tape |
Push the upper part of the mirror surface and tilt it.
Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.
![]() |
Apply protective tape to the area shown in the illustration.
| *a | Protective Tape |
Push the lower part of the mirror surface and tilt it.
Using a moulding remover, disengage the 2 claws at the upper part of the outer mirror as shown in the illustration.
![]() |
Disconnect the mirror heater connector.
| *a | Mirror Heater Connector |
| *b | Blind Spot Monitor Indicator Connector |
Disengage the 2 claws.
Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer mirror.