Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH (for TMMK Made)

HEADLIGHT DIMMER SWITCH (for TMMK Made) > REMOVAL

for Preparation Click here



1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY



2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    E226470E02
  1. Disconnect each connector.

  1. Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

    NOTICE:
    If the claw is pulled with excessive force, it may break.



3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    E226680
  1. Disconnect the connector.

  1. Using a screwdriver, disengage the 3 claws and remove the headlight dimmer switch assembly.