Home › Engine / Hybrid System ยท 6AR-FSE › EMISSION CONTROL › PURGE VALVE

PURGE VALVE > INSTALLATION

for Preparation Click here



1. INSTALL PURGE VALVE (PURGE VSV)


    A338991E01
  1. Install the purge valve (purge VSV) to the intake manifold with the bolt.
    Text in Illustration 
    *1
    Fuel Vapor Hose
    *2
    Fuel Vapor Feed Hose Assembly
    *a
    Left
    *b
    Front
    *c
    Back
    *d
    60°
    *e
    4 to 9 mm (0.157 to 0.354 in.)
    *f
    2 to 7 mm (0.0787 to 0.276 in.)
    *g
    Paint Mark

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the purge valve (purge VSV) connector.

  1. Connect the fuel vapor feed hose assembly to the purge valve (purge VSV) and slide the clip to secure it.

    HINT:
    Make sure the direction of the clip is as shown in the illustration.

  1. Connect the fuel vapor hose to the purge valve (purge VSV) and slide the clip to secure it.

    HINT:
    Make sure the direction of the clip is as shown in the illustration.