Home › Drivetrain ยท U760E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

for Preparation Click here


DESCRIPTION

The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control ECU with the Controller Area Network (CAN).
If there is a problem in this intercommunication, the ECM sets a DTC.

DTC No.
DTC Detection Condition
Trouble Area
U0100
  1. Following conditions are met for 1.25 seconds (1 trip detection logic):
    1. Ignition switch ON
    2. Battery voltage is 10.5 V or more
    3. No intercommunication between engine control ECU and transmission control ECU
ECM

INSPECTION PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0100)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Check if DTCs are output.

    Result:

    Display (DTC Output)
    Proceed to
    U0100
    A
    U0100 and other DTCs
    B



B
GO TO DTC CHART (Click here)
A

REPLACE ECM (Click here)