Home › Drivetrain ยท U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AIR COOLED OIL COOLER

AIR COOLED OIL COOLER > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH


2. REMOVE ENGINE UNDER COVER LH


3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


4. REMOVE ENGINE UNDER COVER RH


5. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the front wheel opening extension pad LH, engine under cover LH and front fender apron seal LH.



    C201682
  1. Remove the refill plug and gasket from the automatic transaxle assembly.



    C239660
  1. Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transaxle assembly.



    C201684E04
  1. Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle assembly.
    Text in Illustration 
    *1
    No. 1 Transmission Oil Filler Tube
    *2
    Hexagon Socket Wrench
    *a
    Overflow Plug Hole

  1. Drain automatic transaxle fluid from the automatic transaxle assembly.



    C201684E04
  1. Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the automatic transaxle assembly.
    Text in Illustration 
    *1
    No. 1 Transmission Oil Filler Tube
    *2
    Hexagon Socket Wrench
    *a
    Overflow Plug Hole

    Torque:
    1.7 N*m{ 17 kgf*cm , 15 in.*lbf }



    C239660
  1. Using a 6 mm hexagon socket wrench, install a new gasket and the overflow plug to the automatic transaxle assembly.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



    C201682
  1. Temporarily install the gasket and refill plug to the automatic transaxle assembly.



6. REMOVE AIR COOLED OIL COOLER


    C153486
  1. Slide the 2 clips and disconnect the 2 oil cooler hoses from the air cooled oil cooler.

  1. Remove the bolt, 2 nuts, and the air cooled oil cooler.