Home › Vehicle Exterior › LIGHTING (EXT) › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT H-LP RELAY


    E223988E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the H-LP relay.



2. INSPECT DIMMER RELAY (for TMMK Made)


    E222294E23
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the DIMMER relay.



3. INSPECT BACK-UP LIGHT RELAY (for TMMK Made)


    E222294E23
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the back-up light relay.