CAN COMMUNICATION SYSTEM > Skid Control ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Skid Control ECU Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK DTC (BRAKE CONTROL SYSTEM) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
|
| ||||
| OK | |
| 2.CHECK FOR OPEN IN CAN BUS LINES (BRAKE ACTUATOR ASSEMBLY BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the A49 brake actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A49-26 (CANH) - A49-14 (CANL) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Brake Actuator Assembly) |
|
| ||||
| OK | ||
| ||