Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the wiper and washer system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

      NEXT


      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage with the ignition switch off.

        Standard Voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      NEXT


      4.CHECK LIN COMMUNICATION SYSTEM*
      1. Check for LIN communication DTC output (Click here).

        Result:
        Result
        Proceed to
        LIN communication DTC is not output.
        A
        LIN communication DTC is output.
        B



      B.
      GO TO LIN COMMUNICATION SYSTEM (Click here)
      A


      5.PROBLEM SYMPTOMS TABLE

        Result:
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Table
        B



      B.
      Go to step 7
      A


      6.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Terminals of ECU (Click here)

      2. Fail-safe chart (Click here)


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END