Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER (for TMC, TMMR Made Manual Seat)

FRONT SEAT CUSHION HEATER (for TMC, TMMR Made Manual Seat) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. REMOVE RECLINING ADJUSTER RELEASE HANDLE


    B270242E03
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the reclining adjuster release handle.
    Text in Illustration 
    *a
    Protective Tape



3. REMOVE VERTICAL ADJUSTING HANDLE (for Driver Side)


    B270246
  1. Remove the screw and vertical adjusting handle.



4. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER


    B270252
  1. Disconnect the rubber band of the separate type front seatback cover.



5. REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)


    B280206
  1. Remove the screw.

  1. Disengage the 5 claws, 6 guides and clip to remove the front seat cushion shield.



6. REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)


    B281086
  1. Remove the screw.

  1. Disengage the 5 claws, 7 guides and clip to remove the front seat cushion shield.



7. REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)


    B280207
  1. Disengage the 5 claws and 6 guides to remove the front seat inner cushion shield.



8. REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)


    B281085
  1. Disengage the 5 claws and 7 guides to remove the front seat inner cushion shield.



9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD


    B280208
  1. Disengage the fastener and separate the front seat airbag assembly wire harness.



    B281498
  1. Disengage the claw and 3 clamps to separate the front seat airbag assembly wire harness.



    B281106
  1. Disconnect the connector.

  1. Disengage the clamp.



    B281107
  1. Disconnect the connector.

  1. Disengage the 2 clamps to separate the seat heater wire harness.



    B280210
  1. Disengage the hook.



    B281500
  1. Disengage each hook and remove the separate type front seat cushion cover with pad.



10. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER


    B269692
  1. Remove the 2 hog rings.



    B439797
  1. Remove the 18 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad.