Home › Engine / Hybrid System ยท 6AR-FSE › EMISSION CONTROL › CANISTER

CANISTER > INSTALLATION

for Preparation Click here



1. INSTALL CANISTER (CHARCOAL CANISTER ASSEMBLY)
  1. Install the canister (charcoal canister assembly) to the vehicle body with the 2 bolts and clip.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



  1. Connect the air line hose to the canister (charcoal canister assembly) and slide the clip to secure it.


    A339001E01


    Text in Illustration 
    *a
    Purge Line Hose
    *b
    Air Line Hose
    *c
    2 to 7 mm (0.0787 to 0.276 in.)
    *d
    90°
    *e
    180°
    *f
    Front
    *g
    Upper
    -
    -

    HINT:
    Engage the clip within the area shown in the illustration.

  1. Connect the purge line hose to the fuel tube and slide the clip to secure it.

    HINT:
    Engage the clip within the area shown in the illustration.

  1. Engage the wire harness clamp.



2. INSTALL FUEL TANK ASSEMBLY
(Click here)