Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for TMC, TMMR Made)

REAR COMBINATION LIGHT ASSEMBLY (for TMC, TMMR Made) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH


    E302933E03
  1. Disconnect the T8 and T16 rear combination light assembly LH connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T8-1 (B) - T8-2 (E)
    Ignition switch ON, turn signal switch in neutral position
    Below 1 V
    Ignition switch ON, turn signal switch in left turn position
    11 to 14 V (60 to 120 times per minute)
    T16-2 (TL) - T16-3 (E)
    Light control switch off
    Below 1 V
    Light control switch in tail position
    11 to 14 V
    T16-1 (B) - T16-3 (E)
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rear Combination Light Assembly LH)
    If the result is not as specified, repair or replace the wire harness or connector.



2. INSPECT REAR COMBINATION LIGHT ASSEMBLY RH


    E302933E04
  1. Disconnect the T13 and T18 rear combination light assembly RH connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T13-1 (B) - T13-2 (E)
    Ignition switch ON, turn signal switch in neutral position
    Below 1 V
    Ignition switch ON, turn signal switch in right turn position
    11 to 14 V (60 to 120 times per minute)
    T18-2 (TL) - T18-3 (E)
    Light control switch off
    Below 1 V
    Light control switch in tail position
    11 to 14 V
    T18-1 (B) - T18-3 (E)
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rear Combination Light Assembly RH)
    If the result is not as specified, repair or replace the wire harness or connector.