Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY (for TMMK Made)

REAR LIGHT ASSEMBLY (for TMMK Made) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR LIGHT ASSEMBLY LH


    E220265E12
  1. Disconnect the T24 rear light assembly LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T24-2 (B) - T24-1 (E)
    Ignition switch ON and shift lever not in R
    Below 1 V
    Ignition switch ON and shift lever in R
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rear Light Assembly LH)
    If the result is not as specified, repair or replace the wire harness or connector.



2. INSPECT REAR LIGHT ASSEMBLY RH


    E220265E13
  1. Disconnect the T23 rear light assembly RH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T23-2 (B) - T23-1 (E)
    Ignition switch ON and shift lever not in R
    Below 1 V
    Ignition switch ON and shift lever in R
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rear Light Assembly RH)
    If the result is not as specified, repair or replace the wire harness or connector.