Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT (for TMMK Made)

PERSONAL LIGHT (for TMMK Made) > INSPECTION

for Preparation Click here



1. INSPECT ROOF CONSOLE BOX ASSEMBLY (w/o Sliding Roof)


    E227732E01
  1. Inspect the personal lights.

    1. Connect a positive (+) lead from the battery to terminal 9 (B) and a negative (-) lead to terminal 1 (GND).

      Result:

      Tester Connection
      Condition
      Specified Condition
      9 (B) - 1 (GND)
      Personal light switches off
      Personal light LH and RH do not come on
      Personal light switch LH on
      Personal light LH comes on
      Personal light switch RH on
      Personal light RH comes on
      Text in Illustration 
      *a
      Component without harness connected
      (Roof Console Box Assembly)

      If the result is not as specified, replace the bulb or roof console box assembly.



2. INSPECT ROOF CONSOLE BOX ASSEMBLY (w/ Sliding Roof)


    E227732E02
  1. Inspect the personal lights.

    1. Connect a positive (+) lead from the battery to terminal 9 (B) and a negative (-) lead to terminal 1 (GND) or 6 (CTY).

      Result:

      Tester Connection
      Condition
      Specified Condition
      9 (B) - 1 (GND)
      Interior light on/off switch off and personal light switches off
      Personal light LH and RH do not come on
      Interior light on/off switch off and personal light switch LH on
      Personal light LH comes on
      Interior light on/off switch off and personal light switch RH on
      Personal light RH comes on
      Interior light on/off switch on and personal light switches off
      Personal light LH and RH comes on
      9 (B) - 6 (CTY)
      Interior light door switch off and personal light switches off
      Personal light LH and RH do not come on
      Interior light door switch off and personal light switches on
      Personal light LH and RH do not come on
      Interior light door switch on and personal light switches off
      Personal light LH and RH comes on
      Text in Illustration 
      *a
      Component without harness connected
      (Roof Console Box Assembly)

      If the result is not as specified, replace the bulb or roof console box assembly.

  1. Inspect the center console spot light.

    1. Connect a positive (+) lead from the battery to terminal 8 (ILLB) and a negative (-) lead to terminal 1 (GND).

      Result:

      Tester Connection
      Condition
      Specified Condition
      1 (GND) - 8 (ILLB)
      Battery positive (+) → Terminal 8 (ILLB)
      Battery negative (-) → Terminal 1 (GND)
      Center console spot light comes on

      If the result is not as specified, replace the roof console box assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (GND) - 10 (RRMP)
    Personal light switches off and interior light on/off switch off
    10 kΩ or higher
    Personal light switches off and interior light on/off switch on
    Below 1 Ω
    6 (CTY) - 10 (RRMP)
    Interior light door switch off
    10 kΩ or higher
    Interior light door switch on
    Below 1 Ω

    If the result is not as specified, replace the roof console box assembly.