AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION |
| 1. INSPECT AIR CONDITIONING PRESSURE SENSOR |
Check the wire harness.
Disconnect the A55 air conditioning pressure sensor connector.
Disconnect the I77 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A55-1 (-) - I77-13 (SG-2) | Always | Below 1 Ω |
| A55-2 (PR) - I77-9 (PRE) | Always | Below 1 Ω |
| A55-3 (+) - I77-10 (S5-3) | Always | Below 1 Ω |
| A55-1 (-) - Body ground | Always | 10 kΩ or higher |
| A55-2 (PR) - Body ground | Always | 10 kΩ or higher |
| A55-3 (+) - Body ground | Always | 10 kΩ or higher |
Reconnect the I77 air conditioning amplifier assembly connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch condition | Specified Condition |
| A55-3 (+) - Body ground | Ignition switch ON | 4.75 to 5.25 V |
Check the air conditioning pressure sensor.
Connect the connector to the air conditioning pressure sensor.
Install a manifold gauge set.
Warm up the engine.
Turn the A/C switch on.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I77-9 (PRE) - I77-13 (SG-2) | Refrigerant pressure: (less than 3025 kPa (30.9 kgf*cm2, 439 psi) and more than 176 kPa (1.8 kgf*cm2, 25 psi) | 0.50 to 4.80 V |
| *a | Component with harness connected (Air Conditioning Amplifier Assembly) |