Home › Vehicle Interior › DOOR LOCK › LUGGAGE COMPARTMENT DOOR LOCK

LUGGAGE COMPARTMENT DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY


  1. Check the operation of the door lock motor.



      B285028E01
    1. Move the door lock to the close (lock) position.

    2. Apply battery voltage to the door lock motor and check operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 1 (B)
      Battery negative (-) → 2 (E)
      Luggage compartment door lock motor open (unlock) operation

      Text in Illustration 
      *a
      Component without harness connected:
      (Luggage Compartment Door Lock Assembly)
      *b
      Close (Lock)
      *c
      Open (Unlock)
      If the result is not as specified, replace the luggage compartment door lock assembly.



  1. Check the operation of the door courtesy switch.



      B285028E02
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Measurement Condition
      Door Lock Condition
      Specified Condition
      2 (E) - 3 (D+)
      Close (Lock)
      10 kΩ or higher
      2 (E) - 3 (D+)
      Open (Unlock)
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected:
      (Luggage Compartment Door Lock Assembly)
      *b
      Close (Lock)
      *c
      Open (Unlock)
      If the result is not as specified, replace the luggage compartment door lock assembly.