Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

NAVIGATION SYSTEM (for Navigation Receiver Type) > Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM


E268438E60


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the I206 navigation receiver assembly connector (for TMC Made).
    Disconnect the I147 navigation receiver assembly connector (for TMMK Made).

  1. Disconnect the I204 No. 1 stereo jack adapter assembly connector (for TMC Made).
    Disconnect the I146 No. 1 stereo jack adapter assembly connector (for TMMK Made).



    E277837E29
  1. Measure the resistance according to the value(s) in the table below (for TMC Made).

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I206-2 (UDO-) - I204-2 (UDO-)
    Always
    Below 1 Ω
    I206-3 (UDO+) - I204-3 (UDO+)
    Always
    Below 1 Ω
    I206-5 (USG1) - I204-5 (USG1)
    Always
    Below 1 Ω
    I206-2 (UDO-) - Body ground
    Always
    10 kΩ or higher
    I206-3 (UDO+) - Body ground
    Always
    10 kΩ or higher
    I206-5 (USG1) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation Receiver Assembly)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



    E289734E41
  1. Measure the resistance according to the value(s) in the table below (for TMMK Made).

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I147-2 (UDO-) - I146-2 (UDO-)
    Always
    Below 1 Ω
    I147-3 (UDO+) - I146-3 (UDO+)
    Always
    Below 1 Ω
    I147-5 (USG1) - I146-5 (USG1)
    Always
    Below 1 Ω
    I147-2 (UDO-) - Body ground
    Always
    10 kΩ or higher
    I147-3 (UDO+) - Body ground
    Always
    10 kΩ or higher
    I147-5 (USG1) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation Receiver Assembly)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)