NAVIGATION SYSTEM (for Radio and Display Type) > Display Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the I155 radio receiver assembly connector.
Disconnect the I207 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I155-13 (VV+) - I207-6 (VV+) | Always | Below 1 Ω |
| I155-14 (VV-) - I207-11 (VV-) | Always | Below 1 Ω |
| I155-13 (VV+) - Body ground | Always | 10 kΩ or higher |
| I155-14 (VV-) - Body ground | Always | 10 kΩ or higher |
| I155-12 (SG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||