NAVIGATION SYSTEM (for Radio and Display Type) > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
![]() |
Disconnect the I155 radio and display receiver assembly connector.
Disconnect the I207 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I155-25 (ADPG) - I207-10 (ADPG) | Always | Below 1 Ω |
| I155-26 (VAR+) - I207-7 (VAR+) | Always | Below 1 Ω |
| I155-28 (VAL+) - I207-8 (VAL+) | Always | Below 1 Ω |
| I155-27 (VA-) - I207-9 (VA-) | Always | Below 1 Ω |
| I155-11 (AGND) - I207-12 (AGND) | Always | Below 1 Ω |
| I155-25 (ADPG) - Body ground | Always | 10 kΩ or higher |
| I155-26 (VAR+) - Body ground | Always | 10 kΩ or higher |
| I155-28 (VAL+) - Body ground | Always | 10 kΩ or higher |
| I155-27 (VA-) - Body ground | Always | 10 kΩ or higher |
| I155-11 (AGND) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||