Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

NAVIGATION SYSTEM (for Navigation Receiver Type) > Navigation Voice Circuit

for Preparation Click here


DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.
Using this circuit, the navigation receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM


E268439E28


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the I65 navigation receiver assembly connector.

  1. Disconnect the I69 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester connection
    Condition
    Specified condition
    I65-2 (RL+) - I69-15 (II1+)
    Always
    Below 1 Ω
    I65-6 (RL-) - I69-14 (II1-)
    Always
    Below 1 Ω
    I69-15 (II1+) - Body ground
    Always
    10 kΩ or higher
    I69-14 (II1-) - Body ground
    Always
    10 kΩ or higher
    I69-18 (SLD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)