Home › Engine / Hybrid System ยท 2GR-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TIMING CHAIN CASE OIL SEAL


    A124982E06
  1. Apply MP grease to a new timing chain case oil seal lip.

  1. Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover edge.
    Text in Illustration 
    *a
    Oil seal tap in depth
    (0 to 1.0 mm)

    SST
    09223-22010  
    09506-35010  

    Oil seal tap in depth:
    0 to 1.0 mm (0 to 0.0393 in.)

    NOTICE:
    1. Keep the lip free of foreign matter.
    2. Do not tap the timing chain case oil seal at an angle.



2. INSTALL CRANKSHAFT PULLEY
  1. Align the pulley set key with the key groove of the pulley, and slide on the pulley.



    A208602E03
  1. Using SST, install the pulley bolt.

    SST
    09213-70011   (09213-70020)
    09330-00021  

    Torque:
    260 N*m{ 2651 kgf*cm , 192 ft.*lbf }

    Text in Illustration 
    *a
    Hold
    V100135
    Turn



3. INSTALL V-RIBBED BELT


    A173434E02
  1. Install the V-ribbed belt.
    Text in Illustration 
    *1
    Water Pump
    *2
    Idler
    *3
    Generator
    *4
    Crankshaft
    *5
    Tensioner
    *6
    A/C Compressor



    A205851
  1. Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.

  1. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.



4. INSTALL FRONT FENDER APRON SEAL RH


5. INSTALL ENGINE UNDER COVER RH


6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH


7. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }