Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL (for LHD)

PARKING BRAKE PEDAL (for LHD) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing.
  1. for TMC, TMMR Made: (Click here)
  2. for TMMK Made: (Click here)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE SHIFT LEVER SUPPORT
  1. for U660E: (Click here)
  2. for U760E TMC, TMMR Made: (Click here)
  3. for U760E TMMK Made: (Click here)
  4. for U761E: (Click here)


4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)
  1. for TMC, TMMR Made:
  2. for TMMK Made:


5. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (w/ Smart Entry and Start System)


    B279162
  1. Disengage the clamp.

  1. Remove the bolt.

  1. Disconnect the connector to remove the No. 1 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the No. 1 indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.



6. REMOVE FLOOR CARPET BRACKET RH
  1. for TMC, TMMR Made:
  2. for TMMK Made:


7. REMOVE AIRBAG SENSOR ASSEMBLY
  1. for TMC, TMMR Made:
  2. for TMMK Made:


8. LOOSEN ADJUSTING NUT


    C237832E01
  1. Remove the lock nut and loosen the adjusting nut.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Adjusting Nut

    NOTICE:
    If the lock nut is removed or loosened, replace the lock nut with a new one (for TMMK Made).



9. SEPARATE NO. 4 PARKING BRAKE CABLE ASSEMBLY


  1. for TMC, TMMR Made:



      C240122E01
    1. Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.
      Text in Illustration 
      *a
      Turn
      *b
      Hold



  1. for TMMK Made:



      C237833E01
    1. Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.
      Text in Illustration 
      *a
      Turn
      *b
      Hold



10. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
  1. Turn back the floor carpet.



    C240125
  1. Remove the clip from the No. 1 parking brake cable assembly.

  1. Remove the bolt and 2 nuts, and separate the No. 1 parking brake cable assembly.



    C237835
  1. Disconnect the parking brake switch connector.



    C237836
  1. Remove the bolt, 2 nuts and parking brake control pedal assembly.