CANISTER (for TMMK Made) > INSTALLATION |
| 1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY |
Apply gasoline to 2 new O-rings, and then install them to the fuel pressure regulator assembly.
Install the fuel pressure regulator assembly to the fuel filter.
| 2. INSTALL FUEL PUMP WITH FILTER ASSEMBLY |
![]() |
Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump with filter assembly.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
Engage the 5 claws of the fuel pump with filter assembly.
![]() |
Engage the 2 claws to install the No. 1 fuel suction support.
Connect the fuel pump harness connector to install the fuel pump harness to the fuel pump with filter assembly.
Engage the 2 claws and install the fuel filter and the fuel pump with filter assembly to the fuel sub-tank.
![]() |
Engage the claw and connect the fuel pump filter hose while aligning it with the installation position of the fuel sub-tank.
Connect the fuel pump harness connector.
| 3. INSTALL FUEL SENDER GAUGE ASSEMBLY |
![]() |
Slide the fuel sender gauge assembly downward and engage the claw (A) to install the fuel sender gauge assembly.
Connect the fuel sender gauge assembly connector.
Install the 2 wire harness protectors to the wire harness.
Engage the 2 wire harness clamps.
| 4. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE |