Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for TMC, TMMR Made Fold Down Seat Type)

REAR SEAT ASSEMBLY (for TMC, TMMR Made Fold Down Seat Type) > INSTALLATION

for Preparation Click here



1. INSTALL REAR SIDE SEATBACK ASSEMBLY LH
  1. Place the rear side seatback assembly LH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Engage the hook to install the rear side seatback assembly LH with the bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Connect the rear seat outer belt assembly to the rear seat shoulder belt guide LH.



2. INSTALL REAR SIDE SEATBACK ASSEMBLY RH
  1. Place the rear side seatback assembly RH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Engage the hook to install the rear side seatback assembly RH with the bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

  1. Connect the rear seat outer belt assembly to the rear seat shoulder belt guide RH.



3. INSTALL REAR SEAT CUSHION LOCK HOOK


    B393388
  1. Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure as for the LH side.



4. INSTALL REAR SEAT CUSHION ASSEMBLY
  1. Place the rear seat cushion assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. w/ Seat Heater System:

    1. Engage the 2 clamps.

    2. Connect the connector.



    B383049
  1. Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.

  1. Confirm that the rear seat cushion assembly is firmly installed.

    NOTICE:
    When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.



5. INSTALL REAR SEATBACK ASSEMBLY RH
  1. Place the rear seatback assembly RH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. w/ Seat Heater System:

    1. Engage the clamp.

    2. Connect the connector.

  1. Install the rear seatback assembly RH with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



    B281625
  1. Engage the fastener as shown in the illustration.

  1. Raise the rear seatback assembly RH.



6. INSTALL REAR SEATBACK ASSEMBLY LH
  1. Place the rear seatback assembly LH in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. w/ Seat Heater System:

    1. Engage the clamp.

    2. Connect the connector.

  1. Install the rear seatback assembly LH with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



    B383046
  1. Engage the fastener as shown in the illustration.

  1. Raise the rear seatback assembly LH.

  1. Connect the rear seat outer belt assembly to the rear seat center shoulder belt guide.



7. INSTALL REAR SEAT HEADREST ASSEMBLY