Home › Vehicle Exterior › HORN › HORN

HORN > INSTALLATION

for Preparation Click here



1. INSTALL LOW PITCHED HORN ASSEMBLY
  1. for TMC, TMMR Made:

    1. Install the low pitched horn assembly with the bolt.

      Torque:
      20 N*m{ 199 kgf*cm , 14 ft.*lbf }

    2. Connect the connector.

  1. for TMMK Made:

    1. Install the low pitched horn assembly with the bolt.

      Torque:
      20 N*m{ 199 kgf*cm , 14 ft.*lbf }

    2. Connect the connector.



2. INSTALL HIGH PITCHED HORN ASSEMBLY
  1. for TMC, TMMR Made:

    1. Install the high pitched horn assembly with the bolt.

      Torque:
      20 N*m{ 199 kgf*cm , 14 ft.*lbf }

    2. Connect the connector.

  1. for TMMK Made:

    1. Install the high pitched horn assembly with the bolt.

      Torque:
      20 N*m{ 199 kgf*cm , 14 ft.*lbf }

    2. Connect the connector.



3. INSTALL COOL AIR INTAKE DUCT SEAL
for TMC, TMMR Made:
for TMMK Made: