AUTOMATIC TRANSAXLE SYSTEM > ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND) |
![]() |
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-8 (E1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to TCM) |
|
| ||||
| OK | |
| 2.INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL) |
![]() |
Disconnect the TCM connector.
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E7-18 (+B) - Body ground | Engine switch on (IG) | 11 to 14 V |
| *a | Front view of wire harness connector (to TCM) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (TCM - NO. 1 INTEGRATION RELAY) |
Remove the No. 1 integration relay from the engine room relay block and junction block assembly.
Disconnect the No. 1 integration relay connector.
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-18 (+B) - 1A-4 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E7-18 (+B) or 1A-4 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||