DTC P0717 Input Speed Sensor Circuit No Signal |
DTC P07BF Input/Turbine Speed Sensor "A" Circuit Low |
DTC P07C0 Input/Turbine Speed Sensor "A" Circuit High |

| *1 | Counter Gear | *2 | Clutch Drum |
| *3 | Output Speed Sensor NC | *4 | Input Speed Sensor NT |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0717 | TCM detects conditions (a), (b) and (c) continuously for 5 sec. or more: (1-trip detection logic) (a) Vehicle speed: 50 km/h (31 mph) or more (b) Park/neutral position switch (R) is OFF (c) Speed sensor (NT): less than 300 rpm |
|
| P07BF | When the speed sensor input voltage is less than 0.1 V for 4.5 seconds or more.(1-trip detection logic) | |
| P07C0 | When the speed sensor input voltage is more than 1.9 V for 4.5 seconds or more.(1-trip detection logic) |

| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (NT) | Input shaft speed/ Min.: 0 rpm Max.: 12750 rpm | Lock-up is
| Data is displayed in increments of 50 rpm |
| 1.INSPECT TRANSMISSION REVOLUTION SENSOR (SPEED SENSOR INSTALLATION) |
Remove the valve body assembly.
![]() |
Make sure that the connector is properly connected, and check the speed sensor installation (Click here).
|
| ||||
| OK | |
| 2.INSPECT TRANSMISSION WIRE |
![]() |
Remove the TCM.
Disconnect the speed sensor connector from the transmission wire.
Measure the resistance according to the value(s) in the table below.
| Tester Condition | Condition | Specified Condition |
| 1 (NTB) sensor side - 1 (NTB) TCM side | Always | Below 1 Ω |
| 2 (NTO) sensor side - 2 (NTO) TCM side | Always | Below 1 Ω |
| 1 (NTB) sensor side - Body ground and other terminals | Always | 10 kΩ or higher |
| 2 (NTO) sensor side - Body ground and other terminals | Always | 10 kΩ or higher |
| *a | Component without harness connected (Transmission Wire) |
| *b | TCM Side |
| *c | Sensor Side |
|
| ||||
| OK | |
| 3.REPLACE TRANSMISSION REVOLUTION SENSOR |
| NEXT | |
| 4.CHECK IF DTC OUTPUT RECURS (SEE IF DTC P0717, P07BF AND/OR P07C0 OUTPUT AGAIN) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the intelligent tester on.
Clear the DTCs (Click here).
Perform the monitor drive pattern (Click here).
Enter the following menus: Powertrain / ECT / DTC.
Read the DTCs using the intelligent tester.
| Display (DTC Output) | Proceed to |
| Only "P0717, P07BF or P07C0" is output | A |
| No output | B |
|
| ||||
| A | ||
| ||